Filter
Top Products
Workman e2050/e2065
Page 3 – 5
Electrical System (Rev. B)
Special Tools
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt–
Ohm–Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
NOTE: Workman e2050 and e2065 vehicles use a 48
volt, DC electrical system. If multimeter is not of the
auto–range type, make sure to properly set multimeter
range before performing any voltage test.
Figure 3
Battery Terminal Protector
Battery Terminal Protector (Toro Part No. 107–0392) is
an aerosol spray that should be used on all battery and
controller terminals to reduce corrosion problems. Apply
terminal protector after cable has been secured to termi-
nal.
Figure 4
Dielectric Gel
Dielectric gel (Toro Part No. 107–0342) should be used
to prevent corrosion of connection terminals. To ensure
complete coating of terminals, liberally apply gel to both
component and wire harness connector, plug connector
to component, unplug connector, reapply gel to both
surfaces and reconnect harness connector to compo-
nent. Connectors should be thoroughly packed with gel
for effective results.
Figure 5
Electrical
System