Filter
Top Products
Workman e2050/e2065Page 5 – 18Chassis (Rev. B)
Pivot Yoke Removal (Fig. 7)
1. Park vehicle on a level surface, turn on/off switch
OFF, set parking brake and remove key from the on/off
switch.
2. Open the battery circuit by carefully removing one of
the battery cables (see Opening Battery Circuit in the
General Information section of Chapter 3 – Electrical
System).
3. Remove cargo bed from the rear frame (see Cargo
Bed Removal in this section).
4. Remove seat base from the front frame (see Seat
Base Removal in this section).
WARNING
Make sure all tires are chocked to prevent the
machine from moving. Before removing the pivot
yoke, make sure front and rear frames are
supported with jack stands. Support both the
front and back of each frame.
5. Remove four (4) cap screws and flat washers secur-
ing the pivot yoke to the rear frame (Fig. 10).
6. Remove cap screw and hardened washer securing
the pivot yoke to the front frame tab.
WARNING
Support pivot yoke while removing it from the
front frame to prevent dropping and causing
serious injury and damage to the machine.
7. Remove four flange head screws and flanged lock
nuts securing the pivot yoke to the front frame. Remove
pivot yoke from the machine.
Pivot Yoke Installation (Fig. 7)
WARNING
Support pivot yoke while installing it to the front
frame to prevent dropping and causing serious
injury and damage to the machine.
1. Position pivot yoke to the front frame so the diamond
pattern faces up (Fig. 10). Secure yoke to front frame
with four flange head screws and flanged lock nuts.
Tighten lower two fasteners first, then tighten upper two
fasteners.
2. Secure pivot yoke to the front frame tab with cap
screw and hardened washer. Torque cap screw from
240 to 290 ft–lb (325 to 393 N–m).
3. Secure pivot yoke to the rear frame with four cap
screws and flat washers.
4. Install seat base to the front frame (see Seat Base
Installation in this section).
5. Install cargo bed to the rear frame (see Cargo Bed
Installation in this section).
6. Reconnect removed battery cable to battery termi-
nals. Install lock washer and nut on battery terminals.
Torque nuts from 115 to 125 in–lb (13 to 14.1 N–m).
1. Pivot yoke
2. Cap screw & flat washer
3. Rear frame
4. Flange lock nut
5. Front frame
6. Diamond pattern
Figure 10
3
4
6
1
2
2
5