Filter
Top Products
Reelmaster 4000–D
Page 4 – 47
Hydraulic System
11. Place housing on clean, lint free cloth. Install 2–1/8”
diameter seal in housing, see Fig. 41.
12. Install 2 bearing races and the needle thrust bearing
in the order shown.
13. Install 1–1/4” diameter dust seal in seal gland bush-
ing, flat or smooth side of dust seal must face down to-
wards bushing, see Fig. 43.
14. Install the quad ring seal in seal gland bushing.
Smooth seal in place with your finger. Do not use any
seal that falls freely into pocket of bushing, see Fig. 43.
15. Install seal gland bushing over the spool end with a
twisting motion. Tap the bushing in place with a rubber
hammer. Make sure the bushing is flush against the
bearing race.
16. Install retaining ring (see Fig. 42 and 43) in housing.
After installing ring, tap on ring end or pry with screwdriv-
er around entire circumference of ring to properly seat
ring in groove.
Figure 41
Figure 42
Figure 43
Hydraulic
System