Filter
Top Products
Reelmaster 4000–D
Page 6 – 4
Axles and Brakes
Rear Wheel Toe–In
After every 800 operating hours or annually, check rear
wheel toe–in.
1. Measure center–to–center distance (at axle height)
at the front and rear of the steering tires (Fig. 3). Front
measurement must be 1/8 inch (0.32 cm) less than the
rear measurement.
2. Loosen clamps at both ends of the tie rods (Fig. 4).
3. Rotate tie rod to move the front of tire inward or out-
ward.
NOTE: Make sure tie rod clamps are positioned so they
do not interfere with steering linkage.
4. Tighten tie rod clamps when the adjustment is cor-
rect.
Figure 3
1. Clamp 2. Tie rod
Figure 4
1
2