Filter
Top Products
Reelmaster 4000–D
Page 4 – 26
Hydraulic System
Special Tools
NOTE: Order special tools from the
TORO SPECIAL
TOOLS AND APPLICATIONS GUIDE (COMMERCIAL
PRODUCTS
). Some tools may also be available from a
local supplier.
Hydraulic Tester – With Pressure and Flow Capabilities – TOR214678
Figure 12
You must have o–ring face seal (ORFS) adapter fittings
for this tester to use it on Toro equipment.
1. INLET HOSE: Hose connected from the system cir-
cuit to the inlet side of the hydraulic tester.
2. LOAD VALVE: If required, upon turning the valve to
restrict flow, a simulated working load is created in the
circuit.
3. LOW PRESSURE GAUGE: Low range gauge to
provide accurate reading at low pressure, 0 – 1000 PSI.
This gauge has a protector valve which cuts out
when pressure is about to exceed the normal range
for the gauge. The cutout pressure is adjustable.
4. HIGH PRESSURE GAUGE: High range gauge to
accommodate pressure beyond the capacity of the low
pressure gauge, 0 – 5,000 PSI.
5. FLOW METER: This meter measures actual oil flow
in the operation circuit, with a gauge rated at 15 GPM.
6. OUTLET HOSE: Hose from the outlet side of the hy-
draulic tester to be connected to the hydraulic system
circuit.