Filter
Top Products
Reelmaster 4000–D Page 5 – 25 Electrical System (Rev. A)
Fuel Stop Solenoid
The solenoid must be energized for the engine to run. It
is mounted on the engine block near the injection pump.
In Place Testing
Note: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
1. Disconnect the connector from the solenoid.
2. Make sure that the solenoid linkages move freely
and are free of dirt, debris, and corrosion.
3. Using a digital multimeter, touch one lead to the pin
of the black wire and the other lead to the pin of the
white wire. The resistance of the pull coil should be
about 0.258 ohms.
4. Using a digital multimeter, touch one lead to the pin
of the black wire and the other lead to the pin of the red
wire. The resistance of the hold coil should be about
10.91 ohms.
5. Connect solenoid to the wiring harness.
Live testing
1. Disconnect connector from the solenoid.
2. Make sure that the solenoid linkages move freely
and are free of dirt, debris, and corrosion.
Note: The solenoid may be removed from the engine
or tested in place.
3. Connect a positive (+) test lead from a 12 VDC
source to the pins of the red and white wires.
4. Touch a negative (–) test lead from the 12 VDC
source to the pin of the black wire. The solenoid should
engage making an audible ”click”.
5. Remove positive (+) voltage from the pin of the
white wire. The solenoid should stay engaged.
6. Remove positive (+) voltage from the pin of the red
wire. The solenoid should release.
7. Reconnect the wires to the solenoid.
1. Fuel stop solenoid
2. Red wire
(
hold coil
)
3. White wire (pull coil)
4. black wire
(
common
)
Figure 20
2
3
4
1
Electrical
System