Filter
Top Products
Workman MD/MDX
Drive Train
Page 5 -- 8
Adjust Ground Speed (Workman MDX)
Workman MDX models use an engine governor for
speed control. Adjust ground speed using the following
procedure.
Vehicles operating at ground speeds greater than
the recommended speed will require further
distances to fully stop. Do not adjust ground
speed greater than specified.
WARNING
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the ignition switch.
Raise and support cargo box.
2. Make sure that the shift lever is in the neutral posi-
tion.
3. Verify engine speed to ensure correct ground speed
as follows:
A. Start engine and hold accelerator pedal to the
floor.
B. Using a tachometer, verify that engine RPM is
from 3250 to 3350 RPM with the accelerator pedal to
the floor.
C. If engine RPM is incorrect, refer to the Briggs and
Stratton Repair Manual found after Chapter 3 --
Briggs & Stratton Gasoline Engine for governor ad-
justment procedure.
4. Lower and secure cargo box after adjustments are
complete.
1. Accelerator cable
2. Accelerator cable end
3. Governor control
Figure 9
1
3
2