Filter
Top Products
Workman MD/MDXPage 7 -- 34Chassis
Front Brake Caliper Service
Disassembly (Fig. 22)
1. If caliper is equipped with anti--rattle clip, remove clip
from caliper, pins and brake pads.
2. Remove pins from caliper by prying with a flat blade
screwdriver through loop in pins.
3. Slide brake pads from caliper. For assembly pur-
poses, note orientation of inner and outer pads as the
pads are not the same.
4. Replace the brake pads if the friction material is worn
to less than 1/32” (0.8 mm).
Assembly (Fig. 22)
1. If brake pads are being replaced, it will be necessary
to push caliper pistons back into the caliper bore before
installing new pads.
2. Slide brake pads into caliper. Make s ure that lining
material on pads is toward brake rotor position.
3. Secure pads into caliper with two (2) pins. Make sure
that pins snap into caliper slots.
4. If caliper is equipped with anti--rattle clip, install clip
to caliper, pins and brake pads.
1. Brake pad
2. Pin (2 used)
3. Clip (if equipped)
Figure 22
1
2
3