Filter
Top Products
Workman MD/MDX Page 7 -- 41 Chassis
Seat Base Removal (Fig. 25)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Flip both seats forward and remove them from the
seat base.
3. Remove parking brake assembly from seat base
(see Parking Brake Disassembly in this section).
4. Unscrew knob from the shift lever. Remove four (4)
short cap screws securing the shift plate to the shift
bracket (Fig. 26).
5. Remove four (4) long cap screws securing the shift
plate to the seat base (Fig. 26). Separate shift bracket
from the choke cable and seat base.
6. Remove eight (8) flange head screws and flat wash-
ers that secure the seat base to the frame.
IMPORTANT: Make sure shift bracket, shift cables,
choke cable and fuel tank do not catch on the seat
base during removal.
7. Lift seat base carefully from the machine.
Seat Base Installation (Fig. 25)
IMPORTANT: Make sure shift bracket, shift cables,
choke cable and fuel tank do not catch on the seat
base during installation.
1. Position seat base carefully to the frame.
NOTE: Do not tighten fasteners securing the seat base
to the frame until all of them are installed.
2. Install eight (8) flange head screws and flat washers
through the frame and into the seat base. Tighten
screws from the middle of the vehicle to the outside.
3. Place shift bracket, shift cables and choke cable
through the opening at the front of the seat base.
4. Position choke cable and shift plate to shift bracket
making sure to capture cable flange. Secure shift plate
to shift bracket with four (4) short cap screws. Screw
knob onto the shift lever (Fig. 26).
5. Position shift plate with shift bracket to the seat base.
Secure shift plate to seat base with four (4) long cap
screws (Fig. 26).
6. Install parking brake assembly to seat base (see
Parking Brake Assembly in this section).
7. Secure seats to seat base.
1. Shift lever
2. Cap screw (short)
3. Shift plate
4. Cap screw (long)
5. Choke cable
Figure 26
3
1
2
4
5
Chassis