Filter
Top Products
7-2 Chapter 7: Troubleshooting
Model 801GC, 801GF & 801GX ¥ Rev. A
Power-on
Under normal conditions, the power light will come
on as soon as the 801G* is turned on. The following
message will be the first thing to appear in the LCD
just after the generator is powered-up:
Normal power-on
The top number indicates the operating firmware
revision level, while the bottom number indicates
the hardware revision level. Please note these num-
bers if you will be contacting Quantum Data with
any questions or problems concerning the operation
of the unit.
If no problems are encountered, the generator will
output the format and test image that were active
when the unit was last powered down.
If the last active image was animated, the LCD will
continue to display the firmware and hardware re-
vision levels until a button is pushed or a knob is
turned. Otherwise, the display will change by itself
after about two seconds.
The information that next appears will depend upon
the operating mode that has been programmed into
the 801G*. The left-hand example shown below is
typical for the normal (default) operating mode of
the 801G*. The example on the right shows a typical
display in the test sequence mode.
Power-on
message
remains
Horizontal Rate
(To nearest KHz)
Vertical Rate
(To nearest Hz)
Signal Format Number
Signal Format Name
Test Image Name
Test Image Number
H31 15=VGA_m18
V60 18=Grill_11