Filter
Top Products
6-39
The top knob moves a selection box among the steps
and parameters on the left side of the screen. The
knob moves the selection box horizontally across the
screen until the step number or last parameter is
selected. Then the next move will be to the adjacent
row. This causes a “snaking” action. If the list goes
beyond the bottom of the screen, turning the knob
further clockwise will cause the list to scroll up. The
example screen shows a blank “Image” entry selected.
The bottom knob normally moves a selection box
up and down the list of choices on the right side.
Long lists will scroll up and down on the screen.
The Change button copies the entry on the right
side to the left side. If the sequence number is se-
lected on the left side, the bottom knob is used to
go through the list of all sequence files in memory.
The example screen shows “GrayBar” selected.
Leaving a Format and/ or Image entry for a given
step empty, will cause the 801G* to use the last format
or image shown above the empty position(s). The
example sequence shown would use format VGA_m18
for step #2 and the FocusCx image for step #3. It
does not matter if the operator is going forward or
backward through the steps.
The Insert, Delete and Move buttons are used to
modify the sequence list. These buttons only work
when a step number is selected. The “Insert” button
puts a blank step at the selected position. All steps
below the insertion point are moved down. The
“Delete” button removes the selected step. All steps
below the deleted step move up. Pressing the “Move”
button lets you move the selected step to another
position in the list. The step is moved by rotating
the top knob. Pressing the “Move” button a second
time will leave the step in the new position.