Filter
Top Products
36 Chapter 2
Basic Operation
Configuring the RF Output
To Configure a Single List Sweep
1. Press
Return > Sweep > Freq & Ampl
This turns the sweep on again. No errors should occur if all parameters for every point have been defined
in the previous editing process.
2. Press
Single Sweep.
The signal generator will single sweep the points in your list. The SWEEP annunciator activates during
the sweep.
3. Press
More (1 of 2) > Sweep Trigger > Trigger Key.
This sets the sweep trigger to occur when you press the
Trigger hardkey.
4. Press
More (2 of 2) > Single Sweep.
This arms the sweep. The ARMED annunciator is activated.
5. Press the
Trigger hardkey.
The signal generator will single sweep the points in your list and the SWEEP annunciator will be
activated during the sweep.
To Configure a Continuous List Sweep
Press
Sweep Repeat Single Cont.
This toggles the sweep from single to continuous. A continuous repetition of the frequencies and amplitudes
configured in the list sweep are now available at the RF OUTPUT connector. The SWEEP annunciator
appears on the display, indicating that the signal generator is sweeping and progression of the sweep is
shown by a progress bar.