Filter
Top Products
106 Chapter 5
Dual Arbitrary Waveform Generator
Using Waveform Markers
To Toggle Markers in an Existing Waveform Sequence
In a waveform sequence, you can independently toggle the operating state of the markers on each waveform
segment. When you build a waveform sequence, the markers on each segment are toggled to the last marker
operating state that was used.
In this example, you learn how to toggle markers within an existing waveform sequence. If you have not
created waveform segments, used them to build and store a waveform sequence, and configured markers for
the waveform sequence, complete the steps in the previous sections, “Creating Waveform Segments” on
page 100, “Building and Storing a Waveform Sequence” on page 101, and “To Place a Marker at the First
Point within a Waveform Segment” on page 104.
1. Press
Mode > Dual ARB > Waveform Sequences.
2. Highlight the desired waveform sequence (for example, TTONE+MTONE).
3. Press
Edit Selected Waveform Sequence.
4. Highlight the desired waveform segment (for example, WFM1:TTONE).
5. Press
Toggle Markers > Toggle Marker 1 or Toggle Marker 2.
6. Highlight the next desired waveform segment.
7. Press
Toggle Marker 1 or Toggle Marker 2.
8. Repeat steps 6 and 7 until you have finished modifying the desired waveform segments.
9. Press
Return.
10. Press
Name And Store.
11. Press
Enter.
The markers are toggled per your selections, and the changes have been saved to the selected sequence file.
An entry (1,2, or 12) in the Mk column indicates that a marker is active. No entry in that column means
that both markers are off, as shown in Figure 5-9.
Figure 5-9
Marker
Column
This entry
shows both
markers on.