A SERVICE OF

logo

Removal and Installation
8-115
HP DesignJet 5000 and 5500 Series Printers Service Manual
Front Platen Assembly (Only Applicable to the 5000 Series)
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Hand Trim - Refer to
Page 8-22.
2. Open the Top Cover.
NOTE Make sure the Carriage is
not in the print Platen area.
3. Remove the following screws (Type
R) from the Front Platen Assembly:
15 T-10 screws in the 60" Model.
11 T-10 screws in the 42" Model.
NOTE Be very careful with these
screws. If they break you will
not be able to remove them.