A SERVICE OF

logo

Removal and Installation
8-59
HP DesignJet 5000 and 5500 Series Printers Service Manual
9. From the right-hand side, lift the
Tensioner Belt off the Scan-Axis
Motor.
10. While supporting the Scan-Axis
Motor, remove 2 T-15 screws (Type
B).
11. Lower the Scan-Axis Motor and
remove from the Printer.
Installation of the Scan-Axis Motor
NOTE Before installation, clean and oil the Slider Rods using the User’s
Slider Rods Lubrification Kit (Refer to Page 9-8).
WARNING When installing the Encoder Strip, make sure it is inserted in the
Encoder Sensor on the rear of the Carriage Assembly.
Encoder Sensor
Insert Encoder Strip
Note: When installing the Belt,
make sure that it is not twisted.