A SERVICE OF

logo

Removal and Installation
8-41
HP DesignJet 5000 and 5500 Series Printers Service Manual
TIP Make sure the Trailing Cable
is flat on the chassis without
bubbles.
NOTE Check the cable and clips are
correctly installed by sliding
the carriage along the
Printer to see if it moves
freely.
5. Connect the Trailing Cables to the
Main PCA.
NOTE Make sure the vertical strips
on Trailing Cable ends are
fully inserted inside the
connectors. The strip should
not be visible when inserted
correctly.
NO BUBBLES
Left Clip locating pin
Right
Clip
Strip will not be
visible when
installed correctly
Install with
edges straight on