A SERVICE OF

logo

Removal and Installation
8-114
HP DesignJet 5000 and 5500 Series Printers Service Manual
Drive Roller Gear
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Hand Cover - Refer
to Page 8-6.
2. Remove the Left Rear Cover - Refer
to Page 8-15.
3. Remove the ISS - Refer to Page 8-64.
4. Remove 1 T-25 screw (Type S) from
the Drive Roller Gear
5. Remove the Drive Roller Gear.
Installation of Gear
WARNING When installing the Drive Roller Gear make sure the screw is
fully tightened.