A SERVICE OF

logo

Removal and Installation
8-108
HP DesignJet 5000 and 5500 Series Printers Service Manual
Booster Fan
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove Right Rear Cover - Refer to
Page 8-16.
2. Remove Left Rear Cover - Refer to
Page 8-15.
3. Remove the Electronics Module -
Refer to Page 8-97.
4. Remove the Lower Right EMC Cover
- Refer to Page 8-32.
5. Remove the 2 T-20 screws (Type L)
from the Booster Fan.
6. To remove the Booster Fan, first slide
it out, then lift and pull out.