A SERVICE OF

logo

Removal and Installation
8-13
HP DesignJet 5000 and 5500 Series Printers Service Manual
TIP To check correct functioning
of serviced parts on the
Printer axis you can do the
following:
a Reinsert the top T-15 screw (Type F) at
the rear of the Printer.
b Hang the Cover on the screw.
c Connect all cables at the Rear of the
Right Cover and turn on the Printer.
Installation of Right Hand Cover
NOTE Make sure the Front Panel cable and the Aerosol Fan cables are
secured inside the Right Hand Cover with cable clamps and
retaining pins.
WARNING Make sure cables pass through slot at rear of chassis on the right
hand side otherwise the Cover cannot be properly installed and
cables may be damaged.