A SERVICE OF

logo

Removal and Installation
8-85
HP DesignJet 5000 and 5500 Series Printers Service Manual
PCI-to-IDE PCA
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the LAN Card - Refer to
Page 8-76.
2. Remove the Left Rear Cover - Refer
to Page 8-15.
3. Remove the Right Rear Cover - Refer
to Page 8-16.
4. Remove the Electronics Module
Cover - Refer to Page 8-79.
5. Disconnect and remove the HDD for
safety reasons - Refer to Page 8-74.
6. Remove 2 T-10 screws that secure the
PCI-to-IDE PCA.
7. Disconnect the PCI-to-IDE PCA and
remove from the Printer.