A SERVICE OF

logo

Removal and Installation
8-84
HP DesignJet 5000 and 5500 Series Printers Service Manual
12. Remove by sliding the Main PCA to
the left and lifting out (see detail
below).
NOTE Detail of Main PCA removal.
Installation of Main PCA
NOTE When the Main PCA has been replaced, perform the Backup
EEROM Page 4-30.
NOTE If you replace the Main PCA and the HDD at the same time you
must perform ALL Service Calibrations (Page 5-3)and the
EEROM Setup Service Utility (Page 4-23.
NOTE If you are not sure how the cables are connected on the Main
PCA, each connector is labelled with the name of the assembly to
which it is connected.
NOTE
When installing the Hard Disk Drive, please refer to the instructions
for the installation of the PCI-to-IDE PCA (Refer to Page
8-86
) and
the installation of the HDD Cable (Refer to Page
8-87
).