Service Tests and Utilities
4-23
HP DesignJet 5000 and 5500 Series Printers Service Manual
EEROM Setup
NOTE This test is only necessary in a situation where you have NOT
been able to perform the EEROM backup test and you have lost
all the EEROM parameters.
The purpose of this Service Utility is to set the Printer Model, the
Serial Number and Japanese Fonts. This is required in the following
situations:
The Main PCA and Hard Disk Drive are replaced at the same
time (EEROM empty).
The Hard Disk Drive and Main PCA are replaced at the same
time and the Main PCA has already been used (valid EEROM
content); the Printer backs up the data to the Hard Disk Drive
storing wrong values for the current Printer.
The main PCA EEROM and the Hard Disk Drive EEROM
backup are valid at initialization but data is conflicting because
they do not come from the same Printer (they have a different
Model Number or Serial Number), and the user has performed
the Backup EEROM Utility incorrectly (See Page 4-30).
Both the Main PCA EEROM and the Hard Disk Drive EEROM
backup are corrupt or fail during Printer initialization.
1. In the Service Utilities submenu, scroll to "1.4 EEROM Setup " and
press Enter.
2. The following options are displayed for EEROM setup. Press Enter
once you have made your selection:
1. Service Utilities
1.3 Altitude Setup
1.2 Prime TUBES
1.4 EEROM Setup
1.5 Reset Life Counters
1.6 Backup EEROM
Top
Enter
Back
n
p
Press Enter
Make Selection
1.1 Turn DRIVE ROLLER
1.4 EEROM Setup
Top
Enter
Back
n
p
Press Enter
Make Selectio
1.4.1 Set Model Number
1.4.2 Set Serial Number
1.4.3 Set Japanese Font
