Filter
Top Products
OUTLET MANAGED PDU
64
• Command Echo: Enables or Disables command echo at the Setup Port. When
disabled, commands that are sent to the Setup Port will still be invoked, but the
actual keystrokes will not be displayed on your monitor. (Default = On.)
• Accept Break: Determines whether the port will accept breaks received from
the attached device. When enabled, breaks received at the port will be passed to
any port that this port is connected to. When disabled, breaks will be refused at
this port. (Default = On.)
Port Mode Parameters:
• Port Name: Allows you to assign a name to the Setup Port.
(Default = undened.)
• Port Mode: The operation mode for this port. (Default = Normal Mode)
Depending on the Port Mode selected, the Outlet Managed PDU will display
additional prompts listed below. In the Text Interface, these parameters are
accessible via a submenu, which will only be active when the appropriate port
mode is selected. In the Web Browser Interface, elds will be "grayed out"
unless the corresponding port mode is selected.
Normal Mode: Allows communication with a local PC and permits access
to command mode. When the Normal Mode is selected, the following mode-
specic parameter can also be dened:
DTR Output: Determines how DTR will react when the port
disconnects. DTR can be held low, held high, or pulsed for 0.5 seconds
and then held high. (Default = Pulse.)