Filter
Top Products
OUTLET MANAGED PDU
142
When switching and reboot commands are executed, the Outlet Managed PDU will
display a "Sure?" prompt, wait for user response, and then complete the command.
The unit will pause for a moment while the command is executed, and then return to
the Plug Status Screen. To Switch Plugs, or initiate a Reboot Cycle, proceed
as follows:
1. Switch Plug(s) On: Type /ON n and press [Enter]. Where "n" is the
alphanumeric number or name of the desired plug or Plug Group.
For example:
/ON A1 [Enter] or /ON ROUTER [Enter]
2. Switch Plug(s) Off: Type /OFF n and press [Enter]. Where "n" is the
alphanumeric number or name of the desired plug or Plug Group. Note that
the "/OFF" command can also be entered as "/OF". For example:
/OFF B2 [Enter] or /OF ROUTER [Enter]
3. Reboot Plug(s): Type /BOOT n and press [Enter]. Where "n" is the
alphanumeric number or name of the desired plug or Plug Group. Note that
the "/BOOT" command can also be entered as "/BO". For example:
/BOOT B3 [Enter] or /BO ATMSWTCH [Enter]
4. Set All Plugs to Power Up Defaults: Type /DPL and press [Enter]. All
plugs permitted by your account will be set to their default On/Off status,
which is dened via the Plug Parameters Menu as described in Section 5.7.
Notes:
• When you have accessed command mode using an Administrator
or SuperUser level account, the Default command will be applied
to all plugs.
• When you have accessed command mode using an account that
permits only User level command access, the Default command
will only be applied to the plugs specifically allowed by that
account.
• The /DPL command is not available in ViewOnly mode.
5. Suppress Command Conrmation Prompt: To execute a power switching
command without displaying the "Sure?" prompt, include the ",Y" option at
the end of the command line. For example:
/ON ROUTER,Y or /BOOT B2,Y