Filter
Top Products
Greensmaster 1000 Grooming Reel KitPage 8 – 13
Installation
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. If removed, reinstall clutch adapter to the reel shaft
(Fig. 15). Torque clutch adapter to 17 ft–lb (2.4 kg–m).
3. Place clutch assembly on the shaft of the clutch
drive adapter. Secure flat washer and lock nut the shaft
of the clutch drive adapter (Fig. 6).
4. Hold drive belt on the driver pulley and slide clutch
onto the clutch adapter shaft while sliding the belt onto
the driven pulley (Fig. 14).
5. Secure flat washer to the clutch adapter shaft with
the lock nut. Torque lock nut from 120 to 150 in–lb (138
to 173 kg–cm) removing all clutch assembly end play
(Fig. 6).
6. Tension drive belt (see Drive Belt Tension in the Ad-
justments section) and tighten socket head cap screw
(Fig. 14).
7. Place belt cover on housing and secure with three
socket head cap screws and washers (Fig. 7).
8. Reinstall clutch knob and poly washer to the clutch
assembly. Tighten both set screws in the clutch knob
(Fig. 6).
Grooming Reel
Kit