Filter
Top Products
Greensmaster 1000 Grooming Reel KitPage 8 – 9
Figure 6
FRONT
RIGHT
1. Belt cover
2. Clutch drive adapter
3. Needle bearing
4. Clutch pin
5. Compression spring
6. Driver pulley
7. Roller bearing
8. Belleville washer
9. Clutch release disc
10. Special screw
11. Flange bushing
12. Set screw
13. Clutch knob
14. Flat washer
15. Lock nut
16. Poly washer
2
3
4
5
6
7
8
9
10
16
11
12
13
14
15
1
CLUTCH
ASSEMBLY
The grooming reel can be removed to reverse the shaft,
replace individual blades, or replace the entire shaft.
The shaft is reversed so that the sharpest edge of the
blades are forward.
Removal
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. Loosen both set screws in the clutch knob. Remove
clutch knob and poly washer from the clutch assembly
(Fig. 6).
3. Remove three socket head cap screws and wash-
ers, then remove belt cover (Fig. 7).
4. In the belt drive housing (46), disassemble the fol-
lowing parts (Fig. 5):
A. Loosen socket head cap screw (37). Pivot idler
pulley (36) away from the drive belt (42). Remove
drive belt from the driven pulley (41).
Note: The driven pulley (41) has left handed threads.
B. Use an allen wrench to remove driven pulley
from the shaft (53).
1. Clutch knob
2. Belt cover
3. Socket head cap screw
and washer
Figure 7
3
1
2
3
5. From the right side of the mower, remove the follow-
ing (Fig. 5):
A. Remove lock nut (1) that secures the shaft (53)
to the bearing housing (4).
B. Remove three flat head socket screws (50) and
lock nuts (3), then remove bearing housing from the
side plate (8) and shaft.
C. Pull grooming reel assembly from the belt drive
housing (46).
Grooming Reel
Kit