Filter
Top Products
Greensmaster 1000/1600 Page 7 – 15 Cutting Unit
Installation
Note: Use new nylon washers and bushings for instal-
lation.
1. Park mower on a level surface. Make sure engine
is OFF. Remove high tension lead from the spark plug.
2. Use grease to hold thrust washers against the in-
side of both frame adjusters (Fig. 25).
3. Install new nylon bushings into both sides of the
frame (Fig. 26).
4. Put anti–seize lubricant on the threads of bedbar
bolts. Install nylon washer, metal washer, and bedbar
bolt to both sides of the frame (Fig. 27).
Use caution when removing the bedbar. Ad-
justing screw springs are under tension and
could release suddenly (Fig. 28).
WARNING
5. Compress spring with channel lock pliers. Remove
pin from both frame adjusters. (Fig. 28).
6. Tighten and then torque both bedbar bolts from 240
to 320 in–lb (280 to 370 kg–cm). Tighten both flange
nuts until metal washers can just rotate freely (Fig. 29).
1. Thrust washer 2. Frame adjuster
Figure 25
1
2
1. Nylon bushing 2. Bedbar
Figure 26
1
2
1. Nylon washer
2. Metal washer
3. Bedbar bolt
4. Flange nut
Figure 27
1
3
2
4
1. Spring 2. Pin (Allen wrench)
Figure 28
2
1
1. Flange nut 2. Bedbar bolt
Figure 29
Torque to
(280 to 370 kg–cm)
1
2
240 to 320 in–lb
Cutting Unit