Filter
Top Products
Greensmaster 1000/1600 Page 7 – 5 Cutting Unit
Special Tools
Order special tools from the
TORO SPECIAL TOOLS
AND APPLICATIONS GUIDE (COMMERCIAL PROD-
UCTS)
.
Some tools may have been supplied with your mower or
available as TORO parts. Some tools may also be avail-
able from a local supplier.
Gauge Bar Assembly – P/N 13–8199
Used to verify height–of–cut.
Figure 3
Backlapping Brush Assembly – TOR299100
Used to apply lapping compound to cutting units while
keeping the operator’s hands at a safe distance from the
rotating reel.
Figure 4
Bedknife Screw Tool – TOR510880
This screwdriver–type bit is made to fit Toro bedknife at-
taching screws. Use this bit with a torque wrench to se-
cure the bedknife to the bedbar.
DO NOT use and air or manual impact wrench with this
tool.
Figure 5
Cutting Unit