Filter
Top Products
Page 91
Section 10 - Options
Dukane Manual Part No. 403-574-01
iQ LinQTM Ethernet/IPTM Module
Part Number - 110- 4644
The EtherNet/IP option module allows the iQ generator
to connect to an EtherNet/IP network. The option
module is an external DIN-rail mounted device that acts
as a bridge between the automation network and an iQ
generator’s RS-232 port. See Figure 10-21 below.
Control Parameters available via EtherNet/IP
1. Set weld method to Time, Energy, or Peak Power. Set
associated value in seconds, joules, or watts.
2. Set Amplitude, Ramp Up Time, and Ramp Down
Time.
3. Enable and set Trigger by Power parameters.
4. Enable and set Hold time.
5. Enable and set Afterburst delay and duration.
6. Enable checking for Suspect Parts. Set maximum and
minimum values for Time, Power and/or Energy.
7. Enable checking for Bad Parts. Set maximum and
minimum values for Time, Power and/or Energy.
8. Configure advanced hardware settings including
Phase, Free Run Frequency, Frequency Lock and
Hold, and Frequency limits.
Parameters that can be obtained via Ethernet/IP
1. All parameters that are congured via EtherNet/IP.
2. Real time data which includes welder state (ultrasound
active or not), frequency, power, and amplitude.
3. Weld cycle data from previous weld which in-
cludes:
• Cycle Count
• Good, Bad, and Suspect Part information
• Process Limit setting exceeded or not reached if Bad
or Suspect Part checking is enabled
• Weld Time
• Weld Energy
• Peak Power
For information on how to control and/or monitor specic
parameters, iQ Generator EtherNet/IP Communication and
Control documentation is available.
Signing a non-disclosure agreement is required to obtain this
documentation.
Figure 10-21 EtherNet/IPTM Module
EtherNet/IP
iQLinQ
+24V
CONFIG
4.65
[118]
1.77
[45]
5.41
[137.5]
in
mm
Front View
Top View
Status LEDs
Connect to iQ Generator’s
J4 Port
Connect to EtherNet/IP
Network