Dukane 403-574-01 Portable Generator User Manual


 
Page  76 
iQ Series, Ultrasonic Generator/Power Supply LS User’s Manual
Dukane Manual Part No. 403-574-01
Optional MPC Interface Connections
Complete Steps 1 - 4 of the basic connections as de-
scribed on Pages 19-20. These involve:
Grounding (optional),
Ultrasound Output,
System Control Inputs/Status Outputs, and
AC Line Input.
Figure 10 - 5 Generator Rear View - Optional MPC Model
Option Panel Modules
A single optional module can be installed in the iQ gener-
ator’s Option Module Panel. See A in Figure 10 - 4 where
the option panel is set up for a Remote Control Module.
Multi- Probe Control
(MPC) Interface Option
Part Number - 110- 4251
The iQ generator can be congured with an optional MPC
Interface circuit board that powers and controls an external
MPC multi- probe control module. This external module,
(that can be ordered with a minimum of two probe controls
up to a maximum of 16 probe controls), must be purchased
In addition to completing these rst four Steps, com-
plete Steps 5 and 6 to wire the MPC Control Inputs/
Status Outputs as described below.
Details about the various system connectors and their
pin assignments are covered below.
Step 5. MPC I/O - MPC control/input signals and sta-
tus output signals are carried in the I/O cables
that should already be connected - See Inputs
(J2) and Outputs (J3) in Figure 10-5.
Step 6. MPC INTERFACE - Attach one end of the
MPC Interface cable (Dukane # 200-1408-XX)
to the MPC Interface connector on the iQ gen-
erator panel - MPC INTERFACE in Figure 10-5.
Connect the other end of the cable to the MPC
INTERFACE connector on the right rear of the
MPC module.
NOTE
The MPC Interface cable is a separate line
item on the iQ generator system order. The
-XX at the end of the cable number speci-
es cable length. This will vary depending
on your MPC installation.
See NOTE on
Page 77.
LINE VOLTAGE:
200-240 Vac
50/60Hz, 10A
PE
MPC INTERFACE
U/S
I
0
J2
J1
J4
J3
Ultrasound Connector
MPC Interface
AC Breaker Switch
Grounding Stud
Inputs
Outputs
See NOTE on the
MPC cable above.