Filter
Top Products
Page 49
Section 6 – Process Control Settings
Dukane Manual Part No. 403-574-01
1. Press CANCEL until you see the Main Menu screen as
it is shown here.
Move the selection indicator to PROCESS SETUP.
2. Press ENTER and you will see the screen as shown
here.
3. Select PROCESS CONTROL, and press ENTER.
With no option boards installed in the generator, you
will get a WELD BY choice of iQ SYSTEM or
AUTOMATION.
4. Select AUTOMATION.
# 1:
OPERATE MODE
PROCESS SETUP
HARDWARE SETUP
PROCESS SETUP
PROCESS CONTROL
PROCESS LIMITS
UTILITIES
AUTOMATED PROBE
WELD CONTROL BY
iQ SYSTEM
AUTOMATION
HOW TO - Have a PLC Control the Ultrasound Activation
Programming the Generator - Some Examples
On the following pages these programming examples cover how to:
• Have a PLC Control the Ultrasound Activation
• Weld by Time
• Weld by Energy
• Adjust Amplitude
• Adjust Ramp Up Time (Soft Start)
• Adjust Ramp Down Time (Soft Stop)
NOTE
Once a primary weld method has been selected (Time, Energy, Peak Power), pressing
the INFO key takes you to a “Hot Key” screen. There you can quickly move to the weld
method’s frequently used programming areas.