Filter
Top Products
4-6
Hardware Installation
4.6. Connecting the Optional MPC-DISPLAY Unit
Use an RJ-45 cable to connect the optional MPC-DISPLAY unit to the MPC unit.
Connect one end of the RJ-45 cable to the “Remote” connector on the MPC front panel;
connect the other end of the cable to the RJ-45 receptacle on the back side of the
MPC-DISPLAY unit as described in Appendix C.2.
The MPC-DISPLAY unit will receive five volts of power (for operation) via the RJ-45 cable
connected to the MPC unit.
To display amperage, kilowatts, volts and temperature for the MPC units that are
attached to the MPC-DISPLAY, press the “Display” button to toggle to the LED for
the desired MPC unit, and then press the “Display Selection” button several times to
select the desired reading; each time the “Display Selection” button is pressed, the
LED indicator adjacent to the button will toggle from Amps to Kilowatts to Volts to
Temperature.
4.7. Rack Mounting
MPC-H Series Units: To install an MPC-H Series (horizontal format) unit in your
equipment rack, simply attach the L-Brackets included with the unit and then mount the
unit in a vacant space in your equipment rack as described in Appendix E.1.
MCP-V Series Units: There are a number of possible rack mounting configurations for
MPC-V Series (vertical format) units; vertical format MPC units can be mounted in the
front or rear of the rack, mounted on the outside of the rack, or mounted in a variety of
different makes and models of equipment racks. For a description of the most common
rack mounting options available for MPC-V units, please refer to Appendix E.
This completes the MPC installation instructions. Please proceed to the next Section for
instructions regarding unit configuration.