Filter
Top Products
4-2
Hardware Installation
• MPC-18H-1 and MPC-18H-2: The cable keeper for these units must be installed
by the user.
1. First make certain that the MPC-18H’s power supply cable is disconnected
from the power source.
2. Install the two standoff screws (included with the cable keeper) in the two
vacant screw holes, located next to the power inlet. When the standoff screws
are in place, thread the two screws supplied with the cable keeper into the top
end of both of the standoff screws.
3. Connect the power cable to the power inlet. Check to make sure that the cable
is firmly seated in the power inlet connector.
4. Install the cable keeper plate, by slipping the plate over the two screws which
protrude from the top of the standoffs. Slip the cable keeper plate into place,
so that one of the notches in the bottom of the plate slips over the power cable,
and the holes in the middle of the plate align with the screws in the tops of the
standoffs.
5. Tighten the two screws into the standoffs to secure the plate and the power
supply cable to the unit. Check to make certain that the cable is held firmly in
place by the cable keeper.
• MPC-20V Series: The cable keepers for 20-outlet, vertical models must be
installed by the user. Note that MPC-20V series units that feature non-detachable
power supply cables do not include cable keepers.
1. First make certain that the MPC’s power supply cable(s) are disconnected
from the power source. Note that some MPC-20V Series units have two power
supply cables and others have only one.
2. Install the screws (included with the cable keeper) in the two vacant screw
holes, located directly below the power inlet(s). Do not overtighten the two
screws; leave enough room for the Cable Keeper assembly to be slid into place
in Step 4 below.
3. Connect the power cable(s) to the power inlet(s). Check to make sure that the
cable(s) are firmly seated in the power inlet connector(s).
4. Install the cable keeper plate, by slipping the plate over the two screws that
were installed under the power inlets in Step 2 above. Slip the cable keeper
into place, so that the notches in the front of the plate slip under the power
cables, securing the cables in place.
5. Tighten the two screws to secure the plate and the power supply cables to
the unit. Check to make certain that the cables are held firmly in place by the
cable keepers.