Filter
Top Products
17-6
Command Reference Guide
/ON Switch Plug(s) ON
Switches selected plugs(s) or Plug Group(s) On, as described in Section 9.2.2. When
the /ON command is used to switch more than one plug, Boot/Sequence Delay Period
will be applied as described in Section 5.7.
Note: When this command is invoked in Administrator Mode or SuperUser
Mode, it can be applied to all MPC plugs and Plug Groups. When this
command is invoked in User Mode, it can only be applied to the plugs and/or
Plug Groups that have been enabled for the account.
Availability: Administrator, SuperUser, User
Format:
/ON [aux] <n>[,Y] [Enter]
Where:
aux If you are directing the command to an outlet on an attached AUX/Remote
MPC unit, then the aux argument must be included in the command line
in order to route the command to the appropriate MPC unit. If your local
MPC unit is not connected to AUX/Remote MPC units, then there is no
need to include this argument in the command line.
n The number or name of the plug(s) or Plug Group(s) that you intend to
Switch On. To apply the command to several plugs, enter a plus sign (+)
between each plug number. To apply the command to a range of plugs,
enter the numbers for the first and last plugs in the range, separated by a
colon character (:). To apply the command to all plugs allowed by your
account, enter an asterisk character (*).
,Y (Optional) Suppresses the command confirmation prompt.
Examples:
Assume that your account allows access to Plug A2 and Plug A3. To switch Plugs A2
and A3 On, without displaying the optional command confirmation prompt, invoke
following command line:
/ON A2+A3,Y [Enter]
To direct the /ON command to plug B4 on an AUX/Remote MPC unit connected to the
AUX2 port on your local MPC unit, invoke the following command line:
/ON aux2 B4 [Enter]