Filter
Top Products
7-13
Alarm Configuration
• Email Message: Enables/Disables email notification for this alarm. (Default = On.)
Note: The Email Message parameter offers four different options: On, Off, On
(Copy to All Triggers) or Off (Copy to All Triggers). If either of the "Copy to All
Triggers" options is selected, then email notification for all other alarms will be
switched On or Off as indicated by this parameter. For example, If "Off (Copy
to All Triggers)" is selected, then Email notification will be disabled for all other
alarms too.
• Address 1, 2, and 3: These parameters are used to select which of the three email
addresses defined via the "Email Messages" menu (see Section 5.9.11) will receive
the email alarm notification messages generated by this alarm. The Address
parameters can be used to select one, or any combination of the addresses defined
via the Email Messages menu. (Default = All On.)
Note: If Email addresses have been previously defined, then the text under the
parameters will list the current, user selected email addresses.
• Subject: This parameter is used to define the text that will appear in the "Subject"
field for all email notification messages generated by this alarm. (Default = "Alarm:
Circuit Breaker Open")
7.4. The Lost Communication with AUX Units Alarm
The Lost Communication with AUX Units Alarm is intended to provide prompt
notification when communication with the optional AUX MPC units is disrupted.
When communication with an attached AUX unit is interrupted, the MPC can provide
notification via Email, Syslog Message or SNMP Trap.
Notes:
• In order for the MPC to provide alarm notification via Email, communication
parameters must first be defined as described in Section 5.9.11.
• In order for the MPC to provide alarm notification via Syslog Message, Syslog
parameters must first be defined and Syslog Messages must be enabled as
described in Section 5.9.2 and Section 11.
• In order for the MPC to provide alarm notification via SNMP Trap, SNMP
parameters must first be defined, and SNMP Traps must be enabled as
described in Section 5.9.7 and Section 12.
To configure the Lost Communication with AUX Alarm, access the MPC command mode
using a password that permits Administrator Level commands, then proceed as follows:
• Text Interface: Type /AC and then press [Enter] to display the Alarm Configuration
Menu. From the Alarm Configuration Menu, type 6 and press [Enter] to access the
configuration menu for the Lost Communication with AUX Units Alarm.
• Web Browser Interface: Click the "Alarm Configuration" link, located on the left
hand side of the screen to display the Alarm Configuration Menu. From the Alarm
Configuration Menu, click on the "Lost Communication with AUX Units" link to
access the configuration menu.