Filter
Top Products
Brake Linkages (SP 5020)
30
29
31
28
26
27
1
2
3
4
5
6
7
8
9
10
16
17
18
19
20
21
22
23
24
13
14
15
20
21
17
4
25
32
11/12
RIGHT
FRONT
Figure 12
1. Curved washer
12. Right bearing bracket
23. Cap screw
2. Lever bracket
13. Washer head screw
24. Spacer
3. Lock nut
14. Flat washer
25. Hourmeter bracket
4. Lock nut
15. Cotter pin
26. Cotter pin
5. Clevis pin
16. Traverse rod
27. Adjustment rod
6. Lock nut
17. Cotter Pin
28. Jam nut
7. Side flange bearing
18. Clevis pin
29. Adjustment clevis
8. Hex head flange
19. Strap
30. Clevis pin
9. Roll pin
20. Cap screw
31. Cotter pin
10. Brake arm
21. Flat washer
32. Brake lever
11. Left bearing bracket
22. Lever assembly
Most parking brake linkage parts can be repaired or re-
IMPORTANT:Make sure to matchmark both parts
placed without removing any interference. However, the
when removing the clevis from either the brake rod
right fender must be removed to work on the parking
or brake lever or removing the brake lever from the
brake lever. cam shaft on the brake assembly, . Marking both
CAUTION
possible burns; allow engine and exhaust sys-
The muffler and exhaust pipe may be hot. Avoid
tem to cool before working near the muffler.
parts will make reassembly and brake adjustment
easier.
2. Remove and replace parts as necessary to repair
brake linkages (Fig. 12).
3. Reinstall right fender if necessary (see Right Fender
Installation).
1. Remove right fender if necessary (see Right Fender
IMPORTANT:Always check and adjust the brakes
Removal).
anytime brake linkages are disassembled or re
-
paired (see Brake Adjustment).
Sand Pro 2020/3020/5020 Page 6 – 13 Wheels, Brakes,and Miscellaneous
Whells, Brakes,
and Miscellaneous