Filter
Top Products
Sand Pro 2020/3020/5020
Page 2 – 4
Product Records and Maintenance
Lubrication
CAUTION
Before servicing or making adjustments to the
machine, stop engine, set parking brake, and re-
move key from the ignition switch.
Lubricate grease fittings regularly with No. 2 general
purpose lithium base grease. Lubricate front wheel
bearing and traction control linkage every 25 hours of
operation. Lubricate steering shaft and steering shaft
sprocket every 100 hours.
Sand Pro 2020/3020 (Early Models)
The three fittings that must be lubricated are: front
wheel bearing (Fig. 1), traction control linkage (Fig. 3)
and steering shaft (Fig. 4).
Sand Pro 2020/3020 (Late Models)
The four fittings to lubricated are: front wheel bearing
(Fig. 1), traction control linkage (Fig. 3) and steering
shaft and steering chain sprocket shaft(Fig. 5).
Sand Pro 5020
The four fittings to lubricate are: front wheel bearing
(Fig. 2), traction control linkage (Fig. 3), and both the
steering shaft and steering chain sprocket shaft (Fig. 6).
NOTE: On the Sand Pro 5020, gain access to the
grease fitting on the traction control linkage (Fig. 3) by
removing the right side panel.
1. Wipe grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing. Wipe up
excess grease.
NOTE: Do not lubricate steering chain unless it be-
comes stiff from rust. If the chain rusts, it may be lubri-
cated lightly with a dry type lubricant.
Figure 1
Figure 2
Figure 3
Figure 4