Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 72
OPERATOR CAB (CONT’D)
Raising (Cont’d)
WARNING
Never modify operator cab by welding, grinding,
drilling holes or adding attachments unless
instructed to do so by Bobcat. Changes to the cab
can cause loss of operator protection from rollover
and falling objects, and result in injury or death.
W-2069-1299
Lowering
Always stop the engine before raising or lowering the cab.
NOTE: Always use the grab handles to lower the cab.
Figure 126
Pull down on the bottom of the operator cab until it stops
at the latching mechanism [Figure 126].
NOTE: The weight of the cab increases when
equipped with options and accessories such
cab door, heater, air conditioning, etc. In
these cases, the cab may need to be raised
slightly from the latch to be able to release the
latch.
Support the cab and release the latching mechanism
(Inset) [Figure 126]. Remove your hand from latching
mechanism when the cab is past the latch stop. Use both
hands to lower the cab all the way.
WARNING
PINCH POINT CAN CAUSE INJURY
Remove your hand from the latching mechanism
when the cab is past the latch stop.
W-2469-0803
Figure 127
Install the plates and nuts [Figure 127] (both sides).
Tighten the nuts to 54-68 Nm torque.
P-31859A
N-20120
P10563
P10564