Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 114
DISPLAY CONTROLLER PANEL SETUP (CONT’D)
Viewing Service Codes (Key Switch)
Figure 194
Press and hold the LIGHTS Button (1) [Figure 194] for
two seconds to view SERVICE CODES in the
HOURMETER / CODE DISPLAY (2). If more than one
SERVICE CODE is present, the codes will scroll on the
HOURMETER / CODE DISPLAY.
NOTE: Corroded or loose grounds can cause
multiple service codes and / or abnormal
symptoms. All instrument panel lights
flashing, alarm sounding, headlights and
taillights flashing, could indicate a bad
ground. The same symptoms could apply if
the voltage is low, such as loose or corroded
battery cables. If you observe these
symptoms, check grounds and positive leads
first.
SERVICE CODES may be either a word (3) [Figure 194]
or a number (4).
The following word errors may be displayed.
REPLY One or both instrument panel(s) not
communicating with the controller.
INPUT The controller not communicating with the
left instrument panel.
CODE The controller is asking for a password.
(Keyless instrument panel only.)
ERROR The wrong password was entered.
(Keyless instrument panel only.)
Viewing Service Codes (Keyless)
The Service Codes will aid your dealer in diagnosing
conditions which can damage your machine.
Figure 195
B-15551
1
2
3
4
B-16163
B-24288
B-24290
B-24291
B-24298
The Display Panel will list the Code Number, (CODE)
hourmeter reading when the error occurred (HOUR),
and the User
(USER) who was logged in to operate the
machine when the error occurred.
A total of 40 Codes can be stored. When more than
40 codes occur, the oldest code will disappear and the
newest code will be in No. 1 position.
Press NEXT to view the next
8 Service Codes. (A total of
40 Codes can be stored.)
Press TOOL / SETUP
Press OWNER UTILITIES
Enter PASSWORD (owner or
master) on Keypad then press
ENTER to Continue.
Press SERVICE CODES