Filter
Top Products
S205 Skid-Steer Loader
41 Operation & Maintenance Manual
ATTACHMENTS (CONT’D)
Installing And Removing The Attachment (Hand
Lever Bob-Tach) (Cont’d)
Removing (Cont’d)
Enter the loader.
Perform the PRE-STARTING PROCEDURE on Page 27.
Start the engine.
Release the parking brake.
Be sure the lift arms are all the way down. Tilt the
Bob-Tach forward.
Figure 83
Move the loader backward, away from the bucket or
attachment [Figure 83].
Installing And Removing The Attachment (Power
Bob-Tach Option)
Installing
The Bob-Tach is used for fast changing of buckets and
attachments. See the appropriate Attachment Operation
& Maintenance Manual to install other attachments.
Perform the PRE-STARTING PROCEDURE. (See PRE-
STARTING PROCEDURE on Page 27.)
Lower the lift arms and tilt the Bob-Tach forward.
Figure 84
Push and hold BOB-TACH “WEDGES UP” switch (Front
Accessory Panel) (1) [Figure 84] until levers are in
unlocked position (2) [Figure 84] (wedges fully raised).
N-18515
2
P-16045
N-
16043AP-
4
P-16043A
B-15993
1
3
P-16046