Filter
Top Products
S205 Skid-Steer Loader
57 Operation & Maintenance Manual
TRANSPORTING THE LOADER ON A TRAILER
Loading And Unloading
WARNING
Adequately designed ramps of sufficient strength are
needed to support the weight of the machine when
loading onto a transport vehicle. Wood ramps can
break and cause personal injury.
W-2058-0494
Be sure the transport and towing vehicles are of
adequate size and capacity. (See Fluid Capacities on
Page 122.)
Figure 115
A loader with an empty bucket or no attachment must be
loaded backward onto the transport vehicle [Figure 115].
The rear of the trailer must be blocked or supported (1)
[Figure 115] when loading or unloading the loader to
prevent the front end of the trailer from raising up.
Fastening
Figure 116
Use the following procedure to fasten the Bobcat Loader
to the transport vehicle to prevent the loader from moving
during sudden stops or when going up or down slopes
[Figure 116].
• Lower the bucket or attachment to the floor.
• Stop the engine.
• Engage the parking brake.
• Install chains at the front and rear loader tie down
positions (Inset) [Figure 116].
• Fasten each end of the chain to the transport vehicle.
P-54213A
1
P-54214A
Alternate Front Tie Down
P-73276
N-19048A