Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 94
FINAL DRIVE TRANSMISSION (CHAINCASE)
Checking And Adding Oil
The chaincase contains the final drive sprockets and
chains. Use the same type of oil as the hydraulic /
hydrostatic system. (See (S205) LOADER
SPECIFICATIONS on Page 119.)
Stop the loader on a level surface.
Stop the engine.
Figure 170
Remove the plug (1) [Figure 170] from the front of the
chaincase housing.
If oil can be reached with the tip of the your finger through
the hole, the oil level is correct.
If the level is low, add oil through the check plug hole until
the oil flows from the hole.
Install and tighten the plug.
Removing Oil From The Chaincase
Remove the check plug (1) [Figure 170] from the front of
the chaincase housing.
Figure 171
Remove the oil from the chaincase [Figure 171].
Recycle or dispose of the used oil in an environmentally
safe manner.
N-18438
1
P-31287B