Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 22
HYDRAULIC CONTROLS (CONT’D)
FRONT Auxiliary Hydraulics Operation
(CONTINUOUS FLOW)
After selecting VARIABLE or MAXIMUM FLOW, press
the front switch (2) [Figure 40] to give the front quick
couplers a constant flow of fluid with the female coupler
being pressurized. (EXAMPLE: Operate a backhoe.)
REVERSE CONTINUOUS FLOW - To set reverse flow
(male coupler pressurized), select VARIABLE or
MAXIMUM FLOW, then, while holding the auxiliary
switch (1) [Figure 40] to the left, press the front
switch (2) [Figure 40]. Reverse flow can be used only
with augers, power rakes, sweepers, tillers, and vibratory
rollers.
To release from continuous operation, press the front
switch (2) [Figure 40] a second time.
REAR Auxiliary Hydraulics Operation (If Equipped)
Figure 41
The switches on the left hand lever control the rear
auxiliary hydraulics.
Press the auxiliary hydraulics button for MAXIMUM
FLOW.
Push the switch (3) [Figure 40] to the right or left to
change the fluid flow direction to rear quick couplers
[Figure 41]. (EXAMPLE: Raise and lower rear
stabilizers.)
Quick Couplers
WARNING
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks. Do
not use your bare hand. Wear safety goggles. If fluid
enters skin or eyes, get immediate medical attention
from a physician familiar with this injury.
W-2072-0496
Figure 42
To Connect: Remove dirt or debris from the surface of
both the male and female couplers, and from the outside
diameter of the male coupler. Visually check the couplers
for corroding, cracking, damage or excessive wear. If any
of these conditions exist, the coupler(s) [Figure 42] must
be replaced.
Install the male coupler into the female coupler. Full
connection is made when the ball release sleeve slides
forward on the female coupler.
To Disconnect: Hold the male coupler. Retract the sleeve
on the female coupler until the couplers disconnect.
P-31831C
P-31847A
P-43614