Filter
Top Products
S205 Skid-Steer Loader
49 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Filling And Emptying The Bucket (ACS - Handles,
SJC - ‘H’ Pattern)
Filling
Figure 100
Figure 101
Lower the lift arms all the way (1) [Figure 100].
Tilt the bucket forward (2) [Figure 100] until the cutting
edge of the bucket is on the ground.
Drive slowly forward into the material. Tilt the bucket
backward (1) [Figure 101] all the way when the bucket is
full.
Drive backward away from the material.
WARNING
Load, unload and turn on flat level ground. Do not
exceed Rated Operating Capacity shown on sign
(decal) in cab. Failure to obey warnings can cause
the machine to tip or roll over and cause injury or
death.
W-2056-0903
Emptying
Figure 102
Keep the bucket low when moving to the area where you
want to empty the bucket.
Raise the lift arms (1) [Figure 102]. Level the bucket (2)
[Figure 102] while raising the lift arms to help prevent
material from falling off the back of the bucket.
Drive forward slowly until the bucket is over the top of the
truck box or bin.
Empty the bucket (2) [Figure 102]. If all material is near
the side of the truck or bin, use the bucket tilt to move it to
the other side.
WARNING
Never dump over an obstruction, such as a post, that
can enter the operator cab. The machine could tip
forward and cause injury or death.
W-2057-0694
B-15520
B-15781
1
2
B-15521
B-15781
1
B-15534
B-15781
1
2