Filter
Top Products
S205 Skid-Steer Loader
87 Operation & Maintenance Manual
ELECTRICAL SYSTEM (CONT’D)
Removing And Installing Battery
WARNING
Batteries contain acid which burns eyes and skin on
contact. Wear goggles, protective clothing and
rubber gloves to keep acid off body.
In case of acid contact, wash immediately with water.
In case of eye contact get prompt medical attention
and wash eye with clean, cool water for at least
15 minutes.
If electrolyte is taken internally drink large quantities
of water or milk! DO NOT induce vomiting. Get
prompt medical attention.
W-2065-1296
Open the rear door.
Figure 155
Disconnect the negative (-) battery cable (1)
[Figure 155].
Remove the battery hold down clamp (2) [Figure 155].
Disconnect the positive (+) battery cable (3)
[Figure 155].
Remove the battery from the loader.
Figure 156
Disconnect the positive (+) battery cable (1)
[Figure 156].
Remove the battery from the loader.
Figure 157
Always clean the battery terminals and cable ends when
installing a new or used battery [Figure 157].
When installing the battery in the loader, do not touch any
metal parts with the battery terminals.
Connect the negative (-) cable last to prevent sparks.
Connect and tighten the battery cables.
Close the rear door before operating the loader.
P-48477
1
2
3
N-18458
1
P-09590
P-09589