Filter
Top Products
S205 Skid-Steer Loader
101 Operation & Maintenance Manual
BOB-TACH (POWER - OPTION)
Inspection And Maintenance
Figure 188
Push and hold the BOB-TACH “WEDGES UP” switch
[Figure 188] until wedges are fully raised. Push and hold
the BOB-TACH “WEDGES DOWN” switch [Figure 188]
until the wedges are fully down.
The levers and wedges must move freely.
WARNING
Bob-Tach wedges must extend through the holes in
attachment. Levers must be fully down and locked.
Failure to secure wedges can allow attachment to
come off and cause injury or death.
W-2102-0588
Figure 189
The wedges (1) must extend through the holes in the
attachment mounting frame (2) [Figure 189].
The spring loaded wedge (1) [Figure 189] must contact
the lower edge of the hole in the attachment (2)
[Figure 189].
If the wedge does not contact the lower edge of the hole
[Figure 189], the attachment will be loose and can come
off the Bob-Tach.
Figure 190
Inspect the mounting frame on the attachment and the
Bob-Tach, linkages and wedges for excessive wear or
damage [Figure 190]. Replace any parts that are
damaged, bent, or missing. Keep all fasteners tight.
Look for cracked welds. Contact your Bobcat dealer for
repair or replacement parts.
Lubricate the wedges (See SERVICE SCHEDULE on
Page 65). (See LUBRICATING THE LOADER on
Page 97).
B-22965
B-15891
N-17022
B-15177
2
1
Wedge must contact
lower edge of hole in
the attachment.
TS-1062B