Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 38
ATTACHMENTS
Choosing The Correct Bucket
WARNING
Never use attachments or buckets which are not
approved by Bobcat Company. Buckets and
attachments for safe loads of specified densities are
approved for each model. Unapproved attachments
can cause injury or death.
W-2052-0500
NOTE: Warranty is void if non-approved attachments
are used on the Bobcat Loader.
The dealer can identify, for each model loader, the
attachments and buckets approved by Bobcat. The
buckets and attachments are approved for Rated
Operating Capacity and for secure fastening to the
Bob-Tach.
The Rated Operating Capacity for this loader is shown on
a decal in the operator cab. (See Fluid Capacities on
Page 122.)
The Rated Operating Capacity is determined by using a
standard dirt bucket, and material of normal density, such
as dirt or dry gravel. If longer buckets are used, the load
center moves forward and reduces the ROC. If very
dense material is loaded, the volume must be reduced to
prevent overloading.
Figure 76
Exceeding the Rated Operating Capacity [Figure 76] can
cause the following problems:
• Steering the loader may be difficult.
• Tracks will wear faster.
• There will be a loss of stability.
• The life of the Bobcat Loader will be reduced.
Use the correct size bucket for the type and density of
material being handled. For safe handling of materials
and avoiding machine damage, the attachment (or
bucket) should handle a full load without going over the
Rated Operating Capacity for the loader. Partial loads
make steering more difficult.
Pallet Forks
Figure 77
The maximum load to be carried when using a pallet fork
is shown on a decal located on the pallet fork frame (1)
[Figure 77].
See your Bobcat dealer for more information about pallet
fork inspection, maintenance and replacement. See your
Bobcat Loader dealer for Rated Operating Capacity when
using a pallet fork and for other available attachments.
WARNING
AVOID INJURY OR DEATH
Do not exceed Rated Operating Capacity. Excessive
load can cause tipping or loss of control.
W-2053-0903
B-15527
WRONG
B-17255
1
Load varies with
model of pallet fork
being used.