Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 30
STARTING THE ENGINE (CONT’D)
Key Switch (Cont’d)
Figure 59
(ACS) Select hand control or foot pedal operation (1)
[Figure 59].
OR
(SJC) Select ‘ISO’ or ‘H’ Control Pattern (2) [Figure 59].
Figure 60
Press the PRESS TO OPERATE LOADER Button (1)
[Figure 60] to activate the BICS system and to perform
hydraulic and loader functions. (See Cold Temperature
Starting on Page 32.)
NOTE: (SJC) The pending mode will flash which will
indicate PRESS TO OPERATE LOADER is
required. The light will flash when key is ON
and continue to flash until the PRESS TO
OPERATE LOADER button is pressed and
thereafter it will light solid. If the mode
(ISO / H) is changed while driving, the active
mode will be solid and the pending mode will
flash. When operation of the machine is
returned to neutral, the active mode will then
turn off and the pending mode will continue to
flash until the PRESS TO OPERATE LOADER
button is pressed.
WARNING
When an engine is running in an enclosed area, fresh
air must be added to avoid concentration of exhaust
fumes. If the engine is stationary, vent the exhaust
outside. Exhaust fumes contain odorless, invisible
gases which can kill without warning.
W-2050-1285
B-15993C
SJC
2
B-15993H
FRONT ACCESSORY PANEL
ACS
1
B-15551
1