Filter
Top Products
S205 Skid-Steer Loader
51 Operation & Maintenance Manual
OPERATING PROCEDURE (CONT’D)
Digging And Filling A Hole (ACS - Handles, SJC -
‘H’ Pattern)
Digging
Figure 104
Lower the lift arms all the way (1) [Figure 104]. Tilt the
bucket forward (2) [Figure 104] until the cutting edge of
the bucket is on the ground.
Drive forward slowly and continue to tilt the bucket
down (2) [Figure 104] until it enters the ground.
Tilt the bucket backward a small amount (3) [Figure 104]
to increase traction and keep an even digging depth.
Continue to drive forward until the bucket is full. When the
ground is hard, raise and lower the cutting edge (1 and 2)
[Figure 104] while driving forward.
Figure 105
Tilt the bucket backward (1) [Figure 105] as far as it will
go when the bucket is full.
Filling
Figure 106
Lower the lift arms (1) [Figure 106] and put the cutting
edge of the bucket on the ground (2) [Figure 106]. Drive
forward to the edge of the hole to push the material into
the hole.
Tilt the bucket forward (2) [Figure 106] as soon as it is
past the edge of the hole.
If necessary, raise the lift arms to empty the bucket.
B-15539
B-15781A
B-15781B
3
2
1
B-15538
1
B-15781
B-15537
1
2
B-15781A
B-15781B