Filter
Top Products
S205 Skid-Steer Loader
Operation & Maintenance Manual 54
OPERATING PROCEDURE (CONT’D)
Digging And Filling A Hole (SJC - ‘ISO’ Pattern)
Digging
Figure 111
Lower the lift arms all the way (1) [Figure 111]. Put the
cutting edge of the bucket on the ground (2)
[Figure 111].
Drive forward slowly and continue to tilt the bucket
down (2) [Figure 111] until it enters the ground.
Raise the cutting edge a small amount (3) [Figure 111]
to increase traction and keep an even digging depth.
Continue to drive forward until the bucket is full. When the
ground is hard, raise and lower the cutting edge (2 and 3)
[Figure 111] while driving forward.
Tilt the bucket backward (3) [Figure 111] as far as it will
go when the bucket is full.
Filling
Figure 112
Lower the lift arms (1) [Figure 112] and put the cutting
edge of the bucket on the ground (2) [Figure 112]. Drive
forward to the edge of the hole to push the material into
the hole.
Tilt the bucket forward (2) [Figure 112] as soon as it is
past the edge of the hole.
If necessary, raise the lift arms to empty the bucket.
B-15539
P-24820
P-24802
3
2
1
B-15537
2
P-24820
P-24802
1